Справочник Пользователя для Husqvarna ZTH6125

English-

47

Refer to the “ZTH electrical system” diagram.

The relays (22) plug into a holder under the 
seat (on the left). The three relays are 
identical and can be plugged into any of the 
sockets in the holder. 

Relay function (working along the holder from 
right to left) is:

•

Brake relay

•

Run relay

•

Start relay

Pull relays directly upwards. If necessary, 
carefully work a screwdriver under the relay 
and lever upwards.

The relays have an asymetric pin pattern and will fit into the sockets in one way only. Press each relay down 
until the body contacts the holder. 

1.

Disconnect the cable connecting the 
battery to the chassis. To avoid 
damaging the battery terminals, use two 
wrenches.

2.

Pull the cables off the contactor.

3.

Remove the contactor (the nuts are 
under the frame plate).

4.

Position the new contactor so that the pin 
for the control cable is towards the 
chassis wall. The black cable connects to 
the front binding screw.

5.

Connect the control cable (yellow) to its 
pin.

6.

Connect the wires to to the battery and 
starter motor as shown in the diagram. 
Replace the connector guards.

7.

Connect the cable between the battery 
and the chassis.

8011-597

8011-598