Справочник Пользователя для Husqvarna 5525PW

Your engine speed has been factory set. 

Your carburetor is not adjustable. 

IMPORTANT:  NEVER TAMPER WITH THE ENGINE GOVERNOR, 
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.  
OVER SPEED ING THE ENGINE ABOVE THE FACTORY HIGH 
SPEED SETTING CAN BE DANGEROUS.  IF YOU THINK THE 
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, 
CONTACT YOUR NEAREST AUTHORIZED SER VICE CEN TER, 
WHICH HAS PROPER EQUIP MENT AND EXPERIENCE TO 
MAKE ANY NEC ES SARY ADJUSTMENTS. 

Immediately prepare your mower for storage at the end of the season or if the unit will not be used for 30 days or more. 

You can fold your lawn mower han dle for storage.

1.  Loosen the two “star” handle knobs on sides of the 

upper handle and allow handle to fold down to the rear.

2.  Loosen the two “standard” handle knobs on sides of 

the lower handle and pivot entire handle as sem bly 
forward and allow it to rest on mower.

3.  Reinstall “standard” knobs and carriage bolts to lower 

handle or handle brackets for safe keeping.

• 

When setting up your handle from the storage posi-
tion, you must manually lock lower handle into mowing 
position.

IMPORTANT:  WHEN FOLDING THE HANDLE FOR STORAGE 
OR TRANSPORTATION, BE SURE TO FOLD THE HANDLE AS 
SHOWN OR YOU MAY DAMAGE THE CONTROL CABLES.

When lawn mower is to be stored for a period of time, clean 
it thoroughly, remove all dirt, grease, leaves, etc.  Store in 
a clean, dry area.

1.  Clean entire lawn mower (See “CLEANING” in the 

Maintenance section of this manual).

2.  Lubricate as shown in the Maintenance section of this 

manual.

3.  Be sure that all nuts, bolts, screws, and pins are securely 

fastened.  Inspect  moving parts for damage, breakage 
and wear.  Replace if necessary.

4.  Touch up all rusted or chipped paint surfaces; sand 

lightly before painting.

The handle on your lawn mower has three (3) height posi-
tions - adjust to height that suits you.

1.  Remove knob and carriage bolt on one side of the 

lower handle.

2.  While holding handle assembly, remove knob and 

car riage bolt from opposite side, align hole in handle 
with desired hole in handle bracket and reassemble 
bolt and knob and tighten securely.

3.  Align opposite side of handle with same positioning 

hole and secure with bolt and knob.