Справочник Пользователя для Husqvarna 03002

OPERATION

TO ADJUST MOWER CUT TING HEIGHT

(See Fig. 18)

The po si tion of the at tach ment lift le ver (A) de ter mines the

cut ting height.

TO ADJUST GAUGE WHEELS (See Fig. 19)

Gauge wheels are prop er ly ad just ed when they are slight ly

off the ground when mower is at the desired cutting height in

operating position. Gauge wheels then keep the deck in prop-

er position to help prevent scalping in most terrain conditions.
NOTE: Adjust gauge wheels with tractor on a flat level

surface.
•

Adjust mower to desired cutting height (See “TO AD JUST

MOWER CUT TING HEIGHT” in this sec tion of manual).

• With mower in desired height of cut po si tion, gauge

wheels should be assembled so they are slightly off

the ground. In stall gauge wheel in ap pro pri ate hole.

Tighten se cure ly.

• Repeat for all, installing gauge wheel in same adjust-

ment hole.

Fig. 18

Fig. 17

• Put attachment lift lever in desired cutting height slot.
The cutting height range is ap prox i mate ly 1" to 4". The

heights are measured from the ground to the blade tip with

the engine not running. These heights are approximate

and may vary depending upon soil conditions, height of

grass and types of grass being mowed.
•

The average lawn should be cut to approximately 2-1/2

inches during the cool season and to over 3 inches

during hot months. For healthier and better looking

lawns, mow often and after moderate growth.

• For best cutting performance, grass over 6 inches

in height should be mowed twice. Make the first cut

relatively high; the second to de sired height.

Fig. 19

TO MOVE FORWARD AND BACKWARD

(See Fig. 17)

The direction and speed of movement is controlled by the

motion control lever. (J)

•

Start tractor with motion control le ver in neutral position.

• Release parking brake.
• Slowly move motion control lever to desired position.

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing

switch. Any attempt by the operator to leave the seat with

the engine running and the attachment clutch engaged will

shut off the engine. You must remain fully and centrally

positioned in the seat to prevent the engine from hesitat-

ing or cutting off when operating your equipment on rough,

rolling terrain or hills.
• Select desired height of cut with attachment lift lever.
• Start mower blades by engaging at tach ment clutch

control.

Fig. 20

CAUTION: Do not operate the mower without

either the en tire grass catcher, on mowers

so equipped, or the deflector shield (S) in

place (See Fig. 20).

TO STOP MOWER BLADES -

• disengage

tach ment clutch con trol.