Справочник Пользователя для Ariens 915087 - 1840
GB - 8
Tools Required
• Adjustable wrench
• Petroleum jelly or dielectric grease.
Unpack Unit
Remove unit and all other components from the shipping
container. Engage transmission bypass lever (see MOVING
UNIT MANUALLY on page 12). Push unit from container
onto a level surface. Disengage transmission bypass lever.
container. Engage transmission bypass lever (see MOVING
UNIT MANUALLY on page 12). Push unit from container
onto a level surface. Disengage transmission bypass lever.
Connect Battery
See Battery Removal and Installation on page 17 and
perform steps 2 and 3 in the installation section.
perform steps 2 and 3 in the installation section.
Place Unit in Operating Position (figure 3):
NOTE: The seat is shipped with the seat positioned as far
back as possible.
back as possible.
1. Tip seat forward and adjust the seat as needed (see
2. Remove eccentric spacers and rotate steering levers to
the operating position. Reinstall spacers. Do not tighten.
3. Adjust steering levers (see ADJUSTING STEERING
Check Engine Oil Level
Refer to Engine Manual.
Check Tire Pressure
Level Mower Deck
Fill Fuel Tank
Check Safety Interlock System
Check function of all controls
ASSEMBLY
WARNING: AVOID INJURY. Read and understand
the entire Safety section before proceeding.
the entire Safety section before proceeding.
WARNING: Safety interlock failure and improper
operation of unit can result in death or serious
injury. Check system before each use to make sure
it is functioning properly.
operation of unit can result in death or serious
injury. Check system before each use to make sure
it is functioning properly.
1. Steering Lever
2. Seat
2. Seat
3. Eccentric Spacer
Figure 3
1
3
1
2