Справочник Пользователя для Dixon 700 Series

D. Slow engine speed with throttle to 

slowest position.

 

E. Turn ignition key to "OFF" (left) 

position.

 

F. Remove the key and wait for all 

movement and all sound to cease 

before dismounting.

 

11.       BRAKING: To brake mower, gently

 

move the Steering Control Levers in the 

direction opposite to travel. If the parking 

brake is engaged with the Steering Control 

Levers in the "IN" position the engine will 

stop.

 

12.        CUTTING HEIGHT ADJUSTMENT: With 

the Cut Height Adjustment Lever latched 

into the top cut height latch. Insert Cut 

Height Stop Pin to desired cutting height. 

Pull Cut Height Adjustment Lever 

rearward and then to the right to clear top 

cut height latch. Lower Cut Height 

Adjustment Lever until it rests on Cut 

Height Stop Pin.

 

13.        ENGAGE MOWER BLADE CLUTCH: 

Set the Blade Clutch Switch to the "ON" 

position. The engine will not start if the 

blade clutch is engaged. If the operator is 

not in the seat, the engine will stop if the 

clutch is engaged.

 

15.        TO FREE WHEEL MACHINE: UNLOCK 

TRANSMISSION: The transmission release levers 

are located on each side of the mower behind the 

rear drive axles and below the engine mounting 

plate. Lift the levers slightly, push them forward 

and then down to release the transmissions for 

free wheeling. To engage the transmissions lift 

the levers slightly, pull them to the rear and then 

down. NOTE: The tractor should never be pulled 

at more than 2 miles per hour or for any 

appreciable distance.

 

 

14.       TO STOP:

 

A. Move Steering Control Levers to neutral 

position and then to the "OUT" position.

 

B. Disengage the mower blade clutch 

by moving the clutch to the "OFF" 

position. 

 

C. Set the parking brake.'"

 

 

 

 

 

 

P-11408 (2/99) 

5