Листовка для American Standard 6060LC
HD-2
© 2007 American Standard Inc.
LIFETIME™ CORNER
WHIRLPOOLS BY AMERICAN STANDARD
HIGH GLOSS ACRYLIC
Revised 7/07
7"
(178mm)
76-3/4"
(1949mm)
54-1/2"
(1384mm)
65-3/8"
(1661mm)
3"
(76mm)
7"
(178mm)
15"
(381mm)
8"
(203mm)
17-3/4"
(451mm)
19-1/2"(C)
(495mm)
65-3/8"
(1661mm)
18"(A)
(457mm)
10"
(254mm)
13-3/4"
(349mm)
CUT OUT IN FLOOR
FOR DRAIN
21-1/2"(H)
(546mm)
DIMENSIONS OF FIXTURES ARE NOMINAL AND MAY VARY WITHIN THE RANGE
OF TOLERANCES ESTABLISHED BY ANSI STANDARDS Z124.1 AND A112.19.7.
C/L
OF
OVERFLOW
OUTLINE OF
CUTOUT
CUTOUT
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
GENERAL SPECIFICATIONS FOR 6060L WHIRLPOOL
WHIRLPOOL ELECTRICAL SPECIFICATIONS
PUMP
76-3/4 x 65-3/8 x 21-1/2 In. (1949 x 1661 x 546mm)
108 Lbs. (49 Kg.)
824 Lbs. (374 Kg.)
86 Gal. (325 L)
71 Gal. (269 L)
71 Gal. (269 L)
48 x 26-1/2 In. (1219 x 673mm)
63 x 50 In. (1600 x 1270mm)
15 In. (381mm)
24 Lbs./Sq.Ft. (116 Kgs./Sq.m)
2.1 HP, 14.4 AMPS,120V.
E-Z INSTALL WHIRLPOOL HEATER
12.0 AMPS,120V.
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR PENINSULA TYPE INSTALLATION. SUPPORT OF
BATH BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. SUPPORT AND ENCLOSING MATERIAL BY OTHERS.
■
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
OPTIONAL 2-WALL TILING BEAD KIT No.TILE-BEAD MUST BE ORDERED SEPARATELY.
▲
CUTOUT TEMPLATE PROVIDED IN SHIPPING BOX. MAY BE REQUESTED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
FITTINGS NOT INCLUDED, MUST BE ORDERED SEPARATELY.
IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING SYSTEM
PIPING, DRAIN OVERFLOW, AND APRON INSTALLATION. MOUNTING HOLES DRILLED BY INSTALLER.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet.