Листовка для American Standard 7242EC
RONDO ELITE™
WHIRLPOOLS BY AMERICAN STANDARD
HIGH GLOSS ACRYLIC
RONDO ELITE™ WHIRLPOOL
Comfortable two person oval design with dual
back support positions and factory installed
grab bar
back support positions and factory installed
grab bar
❏
7242E (specify White 020, Bone 021, or
Linen 222)
• Acrylic with fiberglass reinforcement
• 2.0 HP self-draining pump/motor
• 2.0 HP self-draining pump/motor
with dry run seal
• Ten multi-directional and flow adjustable jets
including:
Two high performance Ideal-flow™ Jets
Eight interchangeable Flex-jets™
Two high performance Ideal-flow™ Jets
Eight interchangeable Flex-jets™
• Three silent air volume controls
• Deck-mounted On/Off control
• Complete factory installed and tested
• Deck-mounted On/Off control
• Complete factory installed and tested
whirlpool system
❏
7242EC (specify White 020, Bone 021, or
Linen 222)
• Same as above with the StayClean™
whirlpool system featuring Antimicrobial
AlphaSan®
AlphaSan®
Nominal Dimensions: 1816 x 1067 x 546mm
(71-1/2” x 42” x 21-1/2")
(71-1/2” x 42” x 21-1/2")
© 2003 American Standard Inc.
HD-006
SPS 7242E
Revised 6/03
Components Needed:
❏
Bath Filler*: (specify finish)
❏
Bath Drain: BATH-DRAIN
(specify Chrome 002, Polished Brass 099,
(specify Chrome 002, Polished Brass 099,
or Satin 295)
Custom Accessories Available:
❏
Pulse Jet Kit: PULSE-JET (two per kit, specify
White 020, Bone 021, or Linen 222)
White 020, Bone 021, or Linen 222)
❏
Soft Jet Kit: SOFT-JET (two per kit, specify
White 020, Bone 021, or Linen 222)
White 020, Bone 021, or Linen 222)
❏
E-Z-Install™ Whirlpool Heater - EZHEAT-100
NOTE: Roughing-in dimensions and product specifica-
tions shown on reverse side of page.
tions shown on reverse side of page.
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• Underwriters Laboratories - Hydromassage
Meets or Exceeds the Following Specifications:
• Underwriters Laboratories - Hydromassage
Bathtubs UL 1795
• ASME A112.19.7M for Whirlpool Appliances
• ANSI Z124.1 for Plastic Bathtubs
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density
• ANSI Z124.1 for Plastic Bathtubs
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density
* See American Standard Faucet Selector
NOTE: E-Z-Install™ Whirlpool Heater is designed to
maintain water temperature during operation. It will not
heat cold water to desired bathing temperature.
maintain water temperature during operation. It will not
heat cold water to desired bathing temperature.