Справочник Пользователя для Ryobi RY15518

7 — English

Never attach or adjust any attachment while power head 
is running. Failure to stop the engine or motor may cause 
serious personal injury.

The edger attachment connects to the power head by means 
of a coupler device. 


  Remove the spark plug wire or disconnect from the power 

supply.



  Remove the hanger cap from the attachment. 



  Loosen the knob on the coupler of the power head shaft.



  Push in the button located on the edger  attachment. Align 

the button with the guide recess on the power head cou-
pler and slide the two shafts together. Rotate attachment 
shaft until button locks into the positioning hole.

 NOTE: If the button does not release completely in the 

positioning hole, the shaft is not locked into place. Slightly 
rotate from side to side until the button is locked into 
place.



  Tighten the knob securely. 

Be certain the knob is fully tightened before operating 
equipment. Check it periodically for tightness during use 
to avoid serious injury.

 Stop the engine or motor and remove the spark plug wire 

or disconnect from the power supply.



  Stop the engine or motor. 



  Loosen the knob.



  Push in the button and twist the shafts to remove and 

separate ends. 

Do not allow familiarity with this product to make you 
careless. Remember that a careless fraction of a second 
is sufficient to inflict serious injury.

Always wear eye protection with side shields marked to 
comply with ANSI Z87.1, along with hearing protection.  
Failure to do so could result in objects being thrown into 
your eyes and other possible serious injuries.

Do not use any attachments or accessories not 
recommended by the manufacturer of this product. The 
use of attachments or accessories not recommended 
can result in serious personal injury.

You may use this product for the purpose listed below:


Edging around walkways, curbing, flower beds and other 
similar areas.

See Figure 4.
When using the edger attachment, hold the unit with your 
right hand on the rear handle and your left hand on the front 
handle. Keep a firm grip with both hands while in operation. 
The edger should be held at a comfortable position with the 
rear handle about hip height.
NOTE: When used with a gas power head, always operate 
at full throttle. Prolonged cutting at partial throttle will result 
in oil dripping from the muffler.

See Figures 5 - 6.
 Stop the engine or motor and remove the spark plug wire 

or disconnect from the power supply.

 Loosen the adjusting knob and move the wheel arm up 

to increase the depth or down to decrease the depth.

 After adjustment is complete, tighten the adjusting knob 

securely.

 Replace the spark plug wire or connect to the power 

supply and start the unit. 

NOTE: Adjust the blade depth from 1/2 in. to 1 in. deep 
initially. Make a shallow cut to test the cutting depth. If the 
cutting depth needs adjusting, this should be done progres-
sively until the desired depth is reached.