Справочник Пользователя для Ariens 921009 ST1130LET

GB - 16

See CONTROLS and FEATURES on 
page 13 for all Controls and Features 
locations.

When Attachment Clutch and then Traction 
Drive Clutch are engaged, the Attachment 
Clutch will remain engaged (lever down) if 
released. To stop attachment, release 
Traction Drive Clutch and both clutches will 
disengage.

Squeeze the Traction 
Drive Clutch Lever 
against the Handlebar 
(1) to engage wheel 
drive for propelling unit. 
Forward speed will 
vary according to snow 
depth and moisture 
content. 
Release lever (2) to 
stop movement.

NOTE: When traveling to or from the area to 
be cleared, press down on the handlebars 
enough to raise the front of the unit slightly off 
the surface. Engage the traction drive clutch 
without engaging the attachment drive clutch.

Squeeze Attachment 
Clutch Lever against 
handlebar (1) to 
engage attachment. 
Release both clutch 
levers (2) to disengage 
power and apply brake 
to attachment.

IMPORTANT: If the 
belt squeals when the 
attachment clutch lever 
is engaged, the 

impeller may be frozen in the auger housing. 
Immediately release the attachment clutch 
lever and move the unit into a heated area to 
thaw.

NOTE: If belt squeals when impeller turns 
freely, see Attachment Clutch/Brake 
Adjustment on page 28.

Key Switch has two 
positions:
1. “Stop” - pulled out
2. “Run” - pushed in
NOTE:  DO NOT twist 
key after it is inserted.

Pushing the primer bulb in adds 
fuel for easier engine start. 
Refer to Starting and Shut Off 
on page 20.

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.

WARNING: To avoid injury to hands 
and feet, always disengage 
clutches, shut off engine, and wait 
for all movement to stop before 
unclogging or working on snow 
thrower.
Keep hands and feet away from 
auger and impeller.

1

2

OL2701

1

2

OL2691

OS1321