Справочник Пользователя для Ariens 921009 ST1130LET
GB - 36
TROUBLESHOOTING
PROBLEM
PROBABLE CAUSE
CORRECTION
Engine will not
crank/start.
crank/start.
1. Fuel tank is empty.
2. Fuel shut-off valve closed.
3. Build up of dirt and residue
2. Fuel shut-off valve closed.
3. Build up of dirt and residue
around
governor/carburetor.
governor/carburetor.
4. Key Switch not in run
position.
5. Electric starter not
functioning.
1. Fill fuel tank.
2. Open fuel shut-off valve.
3. Clean area around
2. Open fuel shut-off valve.
3. Clean area around
governor/carburetor.
4. Put Key Switch into run position.
5. Check for a bad starter or
5. Check for a bad starter or
connections.
Engine stops.
1. Out of fuel.
2. Fuel shut-off valve closed.
3. Mechanical jam in blower
2. Fuel shut-off valve closed.
3. Mechanical jam in blower
rake or impeller.
4. Polluted fuel supply.
5. Faulty spark plug.
5. Faulty spark plug.
1. Fill fuel tank.
2. Open fuel shut-off valve.
3. Turn off engine, remove key, and
2. Open fuel shut-off valve.
3. Turn off engine, remove key, and
wait for all moving parts to stop.
Check for and remove
obstruction and repair before
restart.
Check for and remove
obstruction and repair before
restart.
4. Replace with clean fuel.
5. Replace or clean spark plug.
5. Replace or clean spark plug.
Engine
problems.
problems.
1. See Engine Manual.
Does not
operate in
Forward /
Reverse.
operate in
Forward /
Reverse.
1. Friction disc not adjusted
properly.
2. Traction belt not
functioning.
3. Speed selector not
adjusted properly.
1. Repair or replace friction disc.
2. Repair or replace traction drive
3. Adjust speed selector. See
Small rubber
beads collect
in frame
beads collect
in frame
1. Friction disc wear.
1. Normal friction disc wear. Chunks
or large pieces of rubber mean
friction disc should be checked
and replaced as necessary.
friction disc should be checked
and replaced as necessary.
Unit throws
snow poorly or
does not throw
snow.
snow poorly or
does not throw
snow.
1. Shear bolts broken.
2. Attachment clutch/brake
not adjusted properly.
3. Auger is frozen in place.
4. Ice or debris is obstructing
auger.
5. Attachment drive belts
slipping, worn or damaged.
1. Replace shear bolts (see Shear
2. Adjust attachment clutch/brake
3. Move unit to a warm place to
thaw.
4. With the engine off and auger
disengaged, check for
obstructions and remove.
obstructions and remove.
5. Adjust or replace attachment