Справочник Пользователя для MTD 140

5

NOTE: This Operator’s Manual covers several models.
Snow thrower features vary by model. Not all
features discussed in this manual are applicable to all
snow thrower models.

Before beginning installation, remove all parts from the 
carton and compare them to Figure 1. Carton contents 
are listed below with part numbers in parentheses.

•

Two

 

Ignition Keys (725-0201, 725-1341B

†

)

        

† An ignition key with a plastic cover is included with

select models only. Two standard ignition keys are
included with all other models.

•

Extended Chute Directional Control Assembly
(747-0737, 720-0201A & 726-0100) 

•

One Cotter Pin (714-0507)

•

One Saddle Washer (736-0415)

•

Two Hex Nuts (712-3010)

•

One Eye Bolt (747-0697) w/ Grommet  (735-0234)

NOTE:  All references to left or right side of the snow
thrower is from the operating position only.

Disconnect the spark plug wire

and ground it against the engine to prevent
unintended starting.

•

Remove packing material, if present, and loosen 
the wing knobs found on each side of the handle. 

•

Making sure not to pinch or crimp the cable in the 
process, pivot the upper handle into the operating 
position as illustrated in Figure 2 until it clicks into 
place.

•

Tighten the wing knobs to secure the handle in 
place.

The control cable may already be attached to the 
control handle. If it’s not, complete the following steps 
to attach it to the snow thrower housing.

•

Route the control cable over the crossbar where 
the lower handle meets the upper handle.

•

Pivot the control handle forward and insert the end 
of the control cable into the bottom hole in the 
control handle, from the outside to the inside, as 
shown in Figure 3.

•

Push the plastic fitting into the control housing until 
it clicks in place

†