Справочник Пользователя для Multiquip DCA-600SSK

The MQ Power Model DCA-600SSK  is a 528 kW 

that has been designed as a high quality portable (requires
a trailer for transport) power source for telecom sites, lighting
facilities, power tools, submersible pumps and other
industrial and construction machinery.

The “Engine Control Panel” is provided with the following:
 Tachometer
 Water Temperature Gauge
 Oil Pressure Gauge
 Charging Ammeter Gauge
 Engine Warning Lamp Module
 Throttle Lever (Up to S/N 3698616)
 Ignition Switch (Up to S/N 3698616)
 Engine Speed Switch (S/N 3698617~)
 Pre-Heat Button (S/N 3698617~)
 Pre-Heat Lamp
 Emergency Stop Button
 Battery Switch

The “Generator Control Panel” is provided with the following:
 Output Voltage Adjustment Knob
 Frequency Meter (Hz)
 AC Ammeter (Amps)
 AC Voltmeter (Volts)
 Ammeter Change-Over Switch
 Voltmeter Change-Over Switch
 Panel Light
 Panel Light Switch
 MPEC Module (S/N 3698617~)
 Pilot Lamp

Microprocessor Controlled Alarm System
The DCA-600SSK  generator is equipped with various alarms
and LED status indicators. These alarms and status indicators
are provided to add safety to the generator when operating
under normal conditions. The DCA-600SSK  generator is
designed to shutdown in the event of low oil, high coolant
temperature, low battery and other operation conditions that
may cause severe damage to the generator.

The DCA-600SSK   generator is equipped with the state of
the art "

Open-Delta" excitation system. The open delta

system consist of an electrically independent winding wound
among stationary windings of the AC output section.

There are four connections of the open delta A, B, C, and D.
During steady state loads, the power from the voltage
regulator is supplied from the parallel connections of A to B,
A to D, and C to D. These three phases of the voltage input
to the voltage regulator are then rectified and are the
excitation current for the exciter section.

When a heavy load, such as a motor starting or a short
circuit occurs, the automatic voltage regulator (AVR)
switches the configuration of the open delta to the series
connection of B to C. This has the effect of adding the
voltages of each phase to provide higher excitation to the
exciter section and thus better voltage response during the
application of heavy loads.

The connections of the AVR to the AC output windings are
for sensing only. No power is required from these windings.

The open-delta design provides virtually unlimited excitation
current, offering maximum motor starting capabilities. The
excitation does not have a "

fixed ceiling" and responds

according the demands of the required load up to the
horsepower of the engine.

The  DCA-600SSK  is powered by a 4 cycle,  water cooled,
turbocharged KOMATSU Model SA6D170AE-1 diesel

  engine.

This engine is designed to meet every performance
requirement for the generator. Reference Table 2  for engine
specifications.

In keeping with Multiquip's policy of constantly improving
its products, the specifications quoted herein are subject to
change without prior notice.

The basic controls and indicators for the DCA-600SSK
generator are addressed on the following pages.

Electronic Governor System
The electronic governor system is made up of two parts, an
electronic controller that monitors frequency variation as the
load increases and decreases, and an electronic actuator
that controls the engine throttle.  The frequency is regulated
at ±0.25 to help protect sensitive equipment.