Справочник Пользователя для Multiquip DCA-600SSK

If applicable perform the following:

Apply commercial power to the internal battery charger
receptacle (to ensure good starting) via commercial power.
An external power cord will be required. This capability is an
option.

Apply commercial power to the jacket water heater
receptacle (not necessary for warm climates) via commercial
power. An external power cord will be required. This capability
is an 

option.

4. Close all engine enclosure doors (Figure 44).

Steps 1 thru 19 are referenced
for Engine Operating Panel up
to S/N 3698616. See Figure 41
below. This unit has an 

switch and a throttle handle.

1. Place the 

main, G.F.C.I.  and aux. circuit breakers (Figure 42)

in the “OFF” position prior to starting the engine.

2. Connect the load to the 

UVWO terminals or auxiliary

receptacles as shown in Figure 43. These load
connection points can be found on the output terminal
panel. To gain access to the UVWO terminals or other
power receptacles, unlock the access cover and lift the
door.

3. Tighten the UVWO terminal nuts securely to prevent

load wires from slipping out.

The engine's exhaust contains harmful emissions.
ALWAYS have adequate ventilation when operating.
Direct exhaust away from nearby personnel.

NEVER! manually start the engine with the main, GFCI
or 

auxiliary circuit breakers in the ON (closed) position.