Справочник Пользователя для Ryobi RYI2000T

12 — English

Carbon Monoxide. Using a generator indoors CAN KILL 
YOU IN MINUTES.
Generator exhaust contains high levels of carbon 
monoxide (CO), a poisonous gas you cannot see or smell. 
If you can smell the generator exhaust, you are breathing 
CO. But even if you cannot smell the exhaust, you could 
be breathing CO.



Never use a generator inside homes, garages, 
crawlspaces, or other partly enclosed areas. Deadly 
levels of carbon monoxide can build up in these 
areas. Using a fan or opening windows and doors 
does NOT supply enough fresh air.



ONLY use a generator outdoors and far away from 
open windows, doors, and vents. These openings 
can pull in generator exhaust.

Even when you use a generator correctly, CO may 
leak into the home. ALWAYS use a battery-powered or 
battery-backup CO alarm in the home.
If you start to feel sick, dizzy, or weak after the generator 
has been running, move to fresh air RIGHT AWAY. See 
a doctor. You could have carbon monoxide poisoning.

Failure to properly ground generator can result in 
electrocution, especially if the generator is equipped with 
a wheel kit. National Electric Code requires generator to 
be properly grounded to an approved earth ground. Call 
an electrician for local grounding requirements. 

Do not allow familiarity with this product to make you 
careless. Remember that a careless fraction of a second 
is sufficient to inflict serious injury.

Do not use any attachments or accessories not 
recommended by the manufacturer of this product. The 
use of attachments or accessories not recommended 
can result in serious personal injury.

This generator is designed to supply electrical power for 
operating compatible electrical lighting, appliances, tools, 
and motor loads.



  Only use OUTSIDE and far away from windows, doors, 

and vents.



  NEVER use inside a home or garage, EVEN IF doors and 

windows are open.



  Always position the generator on a flat firm surface.

See Figure 2.
Power:
The power indicator will light when the generator is on and 
the receptacles are operational.
NOTE: If the generator is overloaded, the power indicator 
light will go off. 
Overload:
The overload indicator will light if the generator’s wattage/
amperage capacity is exceeded. To reset the generator, turn 
off the unit and remove all loads. The generator will not reset 
unless the generator is turned off.
Lubricant:
The oil indicator will light and the engine will automatically 
shut off whenever the lubricant level in the engine becomes 
low. The engine may not be restarted until sufficient engine 
lubricant has been added to the generator.
NOTE: It is normal for the indicator lights to illuminate and/
or blink each time the engine is started. Once the engine 
warms up, the lights should default to the pattern above.

Attempting to start the engine before it has been properly 
filled with lubricant will result in equipment failure.

See Figure 3.
Engine lubricant has a major influence on engine perfor-
mance and service life. For general, all-temperature use, 
SAE 10W-30 is recommended. Always use a 4-stroke motor 
lubricant that meets or exceeds the requirements for API 
service classification SJ. 
NOTE: Non-detergent or 2-stroke engine lubricants will 
damage the engine and should not be used.


  Loosen the screw at the top of the engine cover. Remove 

cover and set aside.



  Unscrew the oil cap/dipstick and remove.



  Wipe dipstick clean and re-seat in hole; do not re-thread.



  Remove dipstick again and check lubricant level. 

Lubricant level should fall between the minimum and 
maximum marks on the dipstick.



  If level is low, add engine lubricant until the fluid level 

rises between the minimum and maximum marks on the 
dipstick.



  Replace and secure the oil cap/dipstick.