Справочник Пользователя для Edirol SD-80

Using the internal sound generator

Using the internal 

sound generator

■

In addition to the Part parameters described in the preceding pages, Native mode also allows you to 
adjust the following parameters.

1–16, OFF

This specifies the MIDI channel that is assigned to the part. If this is turned OFF for a part, all MIDI 
messages other than system exclusive messages will be ignored by that part, meaning that it will not 
sound.

ON/OFF, (PATCH: Native mode only)

Turn this ON when you want to use legato, and OFF if you do not. Legato is a function that is valid when 
MONO mode is selected for the part. If Legato is ON, pressing a note while the previous note is still held 
down will cause the sound to be maintained while it shifts to the pitch of the newly pressed note. This lets 
you simulate performance techniques such as the “hammering-on” and “pulling-off” used by guitarists.

Part Velocity Sens Offset (Part Velocity Sensitivity Offset) -63–0–+63

This adjusts the degree to which playing dynamics will affect the volume and cutoff frequency.

This specifies how the volume will change when you play notes that are outside the lower limit of the 
part’s key range. With higher settings of this parameter, the volume will decrease gradually. If you want 
there to be no sound at all when you play below the specified key range, set this to 0.

C-1–UPPER

Specifies the lowest note of the keyboard range for the part.

LOWER–G9

Specifies the highest note of the keyboard range for the part.

0–127

This specifies how the volume will change when you play notes that are outside the upper limit of the 
part’s key range. With higher settings of this parameter, the volume will decrease gradually. If you want 
there to be no sound at all when you play above the specified key range, set this to 0.

fig.5-15

L.Fade value

U.Fade value

Note number

0

127

Level

Lower

Upper