Справочник Пользователя для Edirol SD-80

Using the effects of the internal sound generator

Using the effects of 

the internal sound 

generator

■

On the SD-80, the chorus section can also be used as a delay.
Here you can edit parameters that select either chorus or delay, and specify how the chorus/delay sound 
will be heard and output.

Selection for the type of chorus (or delay).

MAIN, REV, MAIN+REV

Specifies the output destination of the signal that has passed through chorus.

figMAIN:

0–127

Specifies the output level of the signal that has passed through the chorus.

Edit the chorus parameters.
The parameters that can be edited will depend on the type of chorus/delay you specified for 

.

COMMON, PART 1–32

Chorus parameters (chorus type, chorus rate, etc.) exist both outside the sound (COMMON) and within 
the sound (PATCH). This setting specifies which set of parameters the chorus unit will use.

1, 2

Selects the output jacks for the reverb. You can select either OUTPUT 1 or OUTPUT 2 stereo outputs.

0.05–10.00 Hz

Specifies the frequency at which the chorus sound will be modulated.

0–127

Specifies the depth to which the chorus sound will be modulated.

0–127

Specifies the amount of chorused sound that will be returned (fed back) to the input of the chorus. 
Increasing this value will produce a more complex chorus effect.

0 (Off)

Chorus/delay will not be used.

1 (Chorus)

Chorus will be used.

2 (Delay)

Delay will be used.

3 (GM2)

This is the same as GM2 reverb.

Output the signal to the OUTPUT 
of the MIDI sound generator 
block.

.6-1(MAIN)

Output the signal only to reverb.

fig.6-2(REV)

Output the signal to the OUTPUT 
of the MIDI sound generator 
block, as well as to reverb.

fig.6-3(MAIN+REV)