Справочник Пользователя для Yamaha CLP-320
Keyboard Stand Assembly
CLP-320
Owner’s Manual
34
ENGLISH
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Assemble the stand on the flat floor surface.
• Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Use of
• Assemble the stand on the flat floor surface.
• Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Use of
incorrect screws can cause damage or malfunction of the product.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
• To disassemble, reverse the assembly sequence given below.
Remove all parts from the package and make sure you
have all of the items.
have all of the items.
1.
Attach (finger-tighten) C to D
and E.
and E.
1-1 Untie and straighten out the bundled pedal
cord. Don’t discard the vinyl tie. You will
need it later in step 6.
need it later in step 6.
1-2 Align D and E with each end of C.
1-3 Attach D and E to C by finger-tightening the
1-3 Attach D and E to C by finger-tightening the
long screws 1 (6
× 20mm).
Have a Phillips-head (+) screwdriver of the
appropriate size ready.
appropriate size ready.
D
A
B
C
E
Bundled pedal cord
inside
inside
AC Power cord
Assembly Parts
6
× 20 mm long screws ×4 1
6
× 16 mm short screws ×4 2
4
× 12 mm thin screws ×2 3
4
× 20 mm tapping screws
×4 4
Cord holders
× 2
Headphone hanger set
4
× 10 mm thin screws ×2 5 Headphone hanger
L
1-2
1-1
1-3
E
C
D
32