Справочник Пользователя для Kawai CN22
Page
34
6
APPENDICES
2) ASSEMBLY INSTRUCTIONS
Before attempting to assemble the CN22 digital piano, ensure that all parts are included.
A Phillips-head screwdriver will also be required to assemble the unit (not included).
PARTS PROVIDED
Side Panel (A) ............................................. 2 pcs.
Back Panel (B) ..............................................1 pc.
Pedal Board (C) ............................................1 pc.
Screw (D) .................................................... 2 pcs.
Screw (E) .................................................... 4 pcs.
Screw (F) .................................................. 10 pcs.
Bolt (with plain washers and
spring washers) (G) .................................... 4 pcs.
Adjuster (H) ...................................................1 pc.
Headphone hook set
x
Headphone hook .....................................1 pc.
x
Tapping screw ........................................ 2 pcs.
ASSEMBLY SEQUENCE
1. Insert the Adjuster (H) approximately 1 cm into the bottom of
the Pedal Board (C).
Untie and extend the connection cord from the Pedal Board.
Loosely fasten the left and right Side Panels (A) to the Pedal
Board (C) using a single short screw (F) for each side. After
ensuring that the correct Side Panels are used for the left and
right side, and that the pedal cable is not caught between the
assembled parts, securely fasten the Side Panels to the Pedal
Board using an additional four short screws (F) on each side.
ensuring that the correct Side Panels are used for the left and
right side, and that the pedal cable is not caught between the
assembled parts, securely fasten the Side Panels to the Pedal
Board using an additional four short screws (F) on each side.
2. Fasten the Back Panel (B) to the left and right Side Panels (A)
using a single long screw (D) on either side.
Then, fasten the Back Panel to the Pedal Board using four
medium screws (E).
Caution
y Ensure that this section is read thoroughly before attempting to assemble the CN22 digital piano, and
that two or more people work on unit assembly.
y When moving the CN22 digital piano, ensure that hands are not caught in the unit, and that the piano
is not dropped on an individual’s feet.
Screw (D)
ø4
° 30
Screw (E)
ø4
° 20
Screw (F)
ø4
° 14
Bolt (G)
M6
° 25
Adjuster (H)
(C)
(B)
(D)
(E)
(A)
(F’)
Pedal support insert hole
(back of the pedal board)
(A)
(F)
Arrow
(C)
Pedal cable
(H)
CN22_EN.indd 34
2008/10/01 9:25:28