Инструкция для Sony 267

The following is a list of status and error messages that may appear on 
your system from time to time. 

Floppy Disk Controller 
Resource Conflict

The floppy disk controller has requested a 
resource that is already in use.

NVRAM Checksum Error, 
NVRAM Cleared

The NVRAM data was reinitialized due to 
an NVRAM checksum error. 

NVRAM Cleared By Jumper

The Clear CMOS jumper block has been 
changed to the clear position.

NVRAM Data Invalid, 
NVRAM Cleared

Invalid entry in the NVRAM.

Parallel Port Resource Conflict

The parallel port has requested a resource 
that is already in use.

PCI Error Log is Full

This message is displayed when more than 
15 PCI conflict errors are detected. No 
additional PCI errors can be logged.

PCI I/O Port Conflict

Two devices requested the same resource, 
resulting in a conflict.

PCI IRQ Conflict

Two devices requested the same resource, 
resulting in a conflict.

PCI Memory Conflict

Two devices requested the same resource, 
resulting in a conflict.

Primary Boot Device Not 
Found

The designated primary boot device (hard 
disk drive, floppy disk drive, CD-ROM 
drive, or network drive) could not be 
found.

Primary IDE Controller 
Resource Conflict

The primary IDE controller has requested 
a resource that is already in use.

Primary Input Device Not 
Found

The designated primary input device 
(keyboard, mouse, or other, if input is 
redirected) could not be found.

Primary Output Device Not 
Found

The designated primary output device 
(display, serial port, or other, if input is 
redirected) could not be found.

Secondary IDE Controller 
Resource Conflict

The secondary IDE controller has 
requested a resource that is already in use.

Serial Port 1 Resource Conflict

Serial port 1 has requested a resource that 
is already in use.