Листовка для M-AUDIO DCP200

Assembly Instructions

•  The stand should be assembled on a flat floor surface. 

•   Make sure you are using the correct screws for each assembly step, and only use the screws included with your piano. Use of 

incorrect screws can permanently damage the piano.

•  All screws should be tightened after each assembly step (except where otherwise indicated). 

Tool required: Phillips-head (+) screwdriver.

 Remove all parts from their packaging, and verify 

that you have all the following items:

 

 

 Push the feet (C) into the bottom of the legs (A,B), 

with each foot pointing away from the Modesty 

Panel bracket.

 

. 

 Place the cylindrical nuts (G) in the holes near the 

lower bracket in each leg (A and B), with the Phillips 

slots (+) facing up for each nut.

. 

 Use a screwdriver to rotate the cylindrical nut (G) 

into position so that the nut’s threaded hole lines up 

with the hole at the bottom of the leg (A,B). Insert the 

long screw (H) through the bottom of the foot (C) and 

screw it into the cylindrical nut until tight. Do this for 

each of the four nuts.

 

 Remove the cable tie and 

unwrap the pedal connector 

cable on the bottom of the 

Pedal Board.

 

 Turn the adjustable Pedal 

Board support counter-

clockwise until it is moved out 

about an inch.

 

 Attach the left side of the Pedal Board (D) to the left 

leg (A) using two of the four short screws (J).

 

 Attach the right side of the Pedal Board (D) to the 

right leg (B) using the remaining short screws (J).