Справочник Пользователя для Oregon Scientific WMR180A

6

•  Make  sure  the  USB  communications  hub  is  not 

obstructed and is easily accessible to the computer.

•  To  completely  disconnect  from  power,  the  USB 

should be disconnected from the PC.

•  This product should be supplied by an identical USB 

port  complying  with  the  requirements  of  Limited 
Power Source.

.  Secure  the  plastic  base  onto  existing  pole  with  U-

bolts, washers and bolts.

2.  Insert the horizontal attachment bracket into the base.
3.  Using a screw, fix firmly into place. 

4.  Insert wind sensor into the top of the bracket.
5.  Using screws, fix aluminium pole firmly into place.
6.  Slide outdoor sensor onto bracket.

 IMPoRtANt  For best results, point the wind vane North.

7.  Slide the solar panel connector into place on the other 

side of the bracket. Slot the solar panel in place.

8.  Adjust the solar panel. Once facing desired direction, 

use screw to fix in place.

9.  Loosen  the  wing  bolt  and  adjust  the  angle. Tighten 

wing bolt to secure solar panel at desired angle.

0. Remove outdoor sensor from casing. Plug one solar 

panel cable into the socket. Replace sensor into the 
casing.

 NotE  For best results, direct solar panel as follows:

North

Southern Hemisphere

South

Northern Hemisphere

. Plug the other solar panel cables into the socket on 

the wind vane.

 NotE  There are slots to insert the solar power cable 
for convenient storage. There are also fasteners to help 
tighten the cables.

.  Insert  4  type A  screws  into  the  holes  of  the  sensor 

connector.  Screw firmly into place, i.e., fence.

 

The  base  station  and  rain  gauge  should  be  positioned 
within  an  effective  range:  about  00  meters  (328  feet) 
in an open area.
The rain gauge should be mounted horizontally about  
meter (3 feet) from the ground in an open area away from 
trees or other obstructions to allow rain to fall naturally 
for an accurate reading.

to ensure a level plane:
Put a few drops of water on the cross at the base of the 
funnel to check the horizontal level.

1

2

3

4

Water will pool to the center of the cross when the rain 
gauge is level.

WMR180_UM_EN_R7.indd   6

2011/5/30   3:57:13 PM