Инструкция С Настройками для Toshiba TOSVERT VF-AS1

E6581315

32

“CRC” is a system to check errors in communication frames during data transmission.  CRC is

composed of two bytes and has hexadecimal-bit binary values.    CRC values are generated by the
transmission side that adds CRC to messages.    The receiving side regenerates CRC of received
messages and compares generation results of CRC regeneration with CRC values actually received.
If values do not match, data will be aborted.

„

 Flow

In case of the following errors, the return commands from the inverters are added 80h to the com-
mands received by the inverters.    The following error codes are used.

Error Code

Description

01

Command error      (Returned when a command other than 03 or 06 is received)

02

Communication number error (A communication number is not found when Com-
mand 03 or 06 is received)

03

Data range error (Data range error when Command 03 or 06 is received

04

Unable to execute (Command 06 is being received and data cannot be written)
(1) Writing in write-disable-during-operation parameter
(2) Writing in parameter that is executing TYP

A procedure for generating a CRC is:
1, Load a 16–bit register with FFFF hex (all 1’s). Call this

the CRC register.

2. Exclusive OR the first 8–bit byte of the message with the

low–order byte of the 16–bit CRC register, putting the
result in the CRC register.

3. Shift the CRC register one bit to the right (toward the

LSB), zero–filling the MSB. Extract and examine the
LSB.

4. (If the LSB was 0): Repeat Step 3 (another shift).

(If the LSB was 1): Exclusive OR the CRC register with
the polynomial value A001 hex (1010 0000 0000 0001).

5. Repeat Steps 3 and 4 until 8 shifts have been per-

formed. When this is done, a complete 8–bit byte will
have been processed.

6. Repeat Steps 2 through 5 for the next 8–bit byte of the

message. Continue doing this until all bytes have been
processed.

7. The final contents of the CRC register is the CRC value.

8. When the CRC is placed into the message, its upper

and lower bytes must be swapped as described below.

CRC generation

( )

End (Return CRC)

Byte counter n = 0

Byte counter n < Length

CRC = (CRC XOR n

th

 send byte

(0 expanded to word (higher 8
bits))

Nｏ

Yes

Bit counter = 0

CRC initial data: FFFF

Bit counter < 8

C = (Remainder of CRC ÷ 2)

ＣＲＣ >> １

Is remainder (C)
other than 0?

CRC＝

(CRC XOR generating polyno-
mial (A001))

Bit counter +1

Byte counter +1

Yes

Nｏ

Yes

Nｏ

efesotomasyon.com -Toshiba inverter,drive,servo,plc