Справочник Пользователя для Ryobi DP121L
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
WARNING:
To prevent accidental starting that could cause possible
serious personal injury, turn off the tool, remove the
switch key, and unplug the drill press before performing
any maintenance or adjustment.
serious personal injury, turn off the tool, remove the
switch key, and unplug the drill press before performing
any maintenance or adjustment.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
After using the drill press, clean it completely and lubricate
all sliding and moving parts. Apply a light coat of automotive-
type paste wax to the table and column to help keep the
surfaces clean.
all sliding and moving parts. Apply a light coat of automotive-
type paste wax to the table and column to help keep the
surfaces clean.
LUBRICATION
Lower spindle to maximum depth and oil moderately once
every three months.
every three months.
Oil the column lightly every two months.
If cranking becomes difficult, grease gear rack lightly.
The ball bearings in the tool are permanently lubricated.
MOTOR/ELECTRICAL
The induction motor is easy to maintain but must be kept
clean. Do not allow water, oil, or sawdust to accumulate on
or in it. The sealed bearings are permanently lubricated and
need no further attention.
clean. Do not allow water, oil, or sawdust to accumulate on
or in it. The sealed bearings are permanently lubricated and
need no further attention.
HEAD ASSEMBLy AND MOTOR HOUSING
Frequently blow out any dust that may accumulate inside
the head assembly and/or motor housing.
the head assembly and/or motor housing.
GEAR RACK
Periodically lubricate the worm gear and gear rack in order
to keep the vertical movement smooth and to help prolong
the life of the drill press.
to keep the vertical movement smooth and to help prolong
the life of the drill press.
REMOVING THE SPINDLE/CHUCK
The chuck tool is used to remove the chuck and/or spindle
when either an attachment is to be used or when large drill
bits with a tapered shank are to be used.
when either an attachment is to be used or when large drill
bits with a tapered shank are to be used.
Unplug the drill press.
Lower the spindle until the slots in the spindle are
visible.
visible.
Insert the chuck tool into the spindle slot. While support-
ing the chuck in one hand, tap the chuck tool lightly with
a rubber mallet until the chuck and spindle release from
the drill press.
ing the chuck in one hand, tap the chuck tool lightly with
a rubber mallet until the chuck and spindle release from
the drill press.
Remove the chuck tool from the spindle.