Справочник Пользователя для National Instruments FP-AI-112

Скачать
Страница из 16
© National Instruments Corp.
9
FP-AI-112 and cFP-AI-112
using 14 AWG (1.6 mm) wire with a ring lug. Use the 5/16 in. 
panhead screw shipped with the backplane to secure the ring 
lug to the backplane PE ground terminal.
As with any hazardous voltage wiring, make sure that all 
wiring and connections meet applicable electrical codes and 
commonsense practices. Mount terminal bases and backplanes 
in an area, position, or cabinet that prevents accidental or 
unauthorized access to wiring that carries hazardous voltages.
Do not use the [c]FP-AI-112 as the only isolating barrier 
between human contact and working voltages higher than 
250 V
rms
.
Operate the [c]FP-AI-112 only at or below Pollution Degree 2. 
Pollution Degree 2 means that only nonconductive pollution 
occurs in most cases. Occasionally, however, a temporary 
conductivity caused by condensation must be expected.
Do not operate FieldPoint products in an explosive atmosphere 
or where there may be flammable gases or fumes. If you need 
to operate FieldPoint products in such an environment, the 
FieldPoint products must be in a suitably rated enclosure.
Operate the [c]FP-AI-112 at or below Installation Category II. 
Installation Category II is for measurements performed on 
circuits directly connected to the low-voltage installation. 
This category refers to local-level distribution, such as that 
provided by a standard wall outlet.
Specifications
The following specifications are typical for the –40 to 70 °C 
temperature range and for 50 and 60 Hz filter settings unless 
otherwise noted. Specifications are subject to change without 
notice.
Input Characteristics
Number of channels.......................... 16
ADC resolution................................. 16 bits at 50 or 60 Hz;
10 bits at 500 Hz 
(refer to table)
Type of ADC..................................... Delta-sigma