Справочник Пользователя для Xantrex Technology 815-2524-02

40

Freedom SW 230V Installation Guide

Installing the Inverter/Charger

3.

Press the INVERTER ENABLE button. Verify that the 
INVERTER ENABLED LED status light illuminates.

4.

Connect the Freedom SW 230V to the test load by closing the 
AC breaker that controls the circuit that the test load is 
connected to.

If the light bulb illuminates, the Invert mode is working.

5.

Press the Inverter Enable button to disable the inverter.

The INVERTER ENABLED LED status light is off.

1.

Close the AC supply breaker to supply AC power to the unit.

2.

After a few seconds, verify that the AC/Charge light on the 
front panel is turned on (indicating that the batteries are being 
charged).

3.

Disable the AC source and turn off the inverter by pressing the 
Inverter Enable button.

4.

Connect the test load to the AC output connection of the unit.

5.

Enable the AC source and the test load should turn on after ten 
seconds.

Your installation is now complete. The Freedom SW 230V Inverter/
Charger is ready for use.

The preceding tests use a light test load (a light bulb) as a test case. 
If you encounter problems when using a load over 1000 watts (for 
example, a hair dryer or microwave), see the troubleshooting 
information in the Freedom SW 230V Sine Wave Inverter/Charger 
Owner’s Guide.

Freedom SW 3K2K 230V InvChg Install Guide.book  Page 40  Friday, June 20, 2014  9:11 AM