Справочник Пользователя для Mitsubishi Electronics MDS-R
Appendix 1. Cable and Connector Specifications
A1 - 23
(5) Soldering a contact
Temporarily solder each contact and core wire, and then solder the core wire on the contact.
When using a drain wire, attach a heat shrink tube on it after soldering.
(Note) Take care not to stick out the core wire from the contact.
When using a drain wire, attach a heat shrink tube on it after soldering.
(Note) Take care not to stick out the core wire from the contact.
Take care to prevent solder from adhering to the edge of solder cup.
Connector name
Applicable contact
Applicable cable
CM10-AP10S CM10-#22SC-S1 AWG20 or less
CM10-AP2S
CM10-#22SC-S2
AWG16 or less
Solder
A
Contact
Core wire
Cable
Detail A
Drain wire
Heat shrink tube
Soldering drain wire