Справочник Пользователя для Toshiba B-EV4D SERIES

ENGLISH VERSION EO1-33088 

2.8 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities

E2-16 

The test print contents should be changed by the following commands 

and parameters: 

 

PROGRAM VERSION: VX.XX  XXXX --- Firmware version and checksum 
TONE ADJUST: +XX ------------------------- Print tone fine adjustment value 
FEED ADJUST: +XX.Xmm ------------------ Print position fine adjustment value 
CUT POSITION ADJUST: +XX.Xmm ----- Cut position fine adjustment value 
BACKFEED ADJUST: +XX.Xmm ---------- Back feed amount fine adjustment value 
PARAMETER:  [PC-850][0] ----------------- Character code selection and Font “0” 

selection  

 [9600][8][1][NONE][2] --- Baud 

rate, 

Data length, Stop bit length, 

Parity, and Transmission control of RS-
232C 

 

[ON][AUTO][FEED][B0]----- Forward feed wait function, Control code, 

Feed key function, and Euro code 

X-COORDINTE ADJUST: +XX.Xmm ----- X-coordinate fine adjustment value 
SENSOR SELECTION: TRANSMISSIVE - Sensor selection and sensitivity 
SENSOR ADJ. VALUE:  

TRANSMISSIVE[XX] REFLECTIVE[XX]

  -- Sensor setting value 

 

PRINT SPEED: 5IPS --------------------------- Print Speed 
FLASH ROM:4MB ----------------------------- Flash ROM Capacity 
SDRAM: 8MB----------------------------------- SDRAM Capacity 
USER MEMORY: [X KB][0 KB] ------------ User Memory Capacity 
TTF AREA: [XXXKB][XXXKB]------------ True type font storage area, Main PC board 

and optional memory card 

EXT CHAR AREA: [XXXKB][XXXKB] -- Writable character storage area, Main PC 

board and optional memory card 

BASIC AREA: [XXXKB][XXXKB] -------- BASIC file storage area, Main PC board and 

optional memory card 

PC SAVE AREA: [XXXKB][XXXKB] ----- PC save storage area, Main PC board and 

optional memory card 

INFORMATION: ------------------------------- Printed only when some information is 

stored in the flash ROM 

TOTAL FEED----------------------------------- Total feed distance  
TOTAL PRINT: 0.00 km ---------------------- Total Print distance 
TOTAL CUT: 0 --------------------------------- Total Cut Count 
IP ADDRESS: 192.168.10.20 -----------------  
SUBNET MASK: 255.255.255.0 -------------  
GATEWAY: 0.0.0.0 ----------------------------  
MAC ADDRESS: XX-XX-XX-XX-XX ----  
DHCP: Disabled---------------------------------  
DHCP CLIENT ID:  

FFFFFFFFFFFFFFFFFFFF FFFFFFFFFFFF

----  

SOCKET COMM.: Enabled-------------------  
SOCKET COMM. PORT: 08000-------------  
 

 

Network setting values