Справочник Пользователя для IBM TDS800
54
Océ TDS800 User Manual
The Correction key
use the Correction key to do the following:
1
Press the Correction key one time to return to the default value of the active
setting.
setting.
2
Press the Correction key two times to set the numeric display to 1.
3
Press the Correction key three times to return to the top layer of the Scanner
Operator Panel. When job templates are enabled in the Océ Settings Editor the
top layer shows the job templates. When job templates are not enabled in the
Océ Settings Editor, the top layer shows the ‘Custom’ section.
Operator Panel. When job templates are enabled in the Océ Settings Editor the
top layer shows the job templates. When job templates are not enabled in the
Océ Settings Editor, the top layer shows the ‘Custom’ section.
When ‘Automatic feed’ is selected for a single sheet job, this setting stays
active.
active.
Job interrupt only stays active for one job. You have to press the Job interrupt
key before each new job you want to give interrupt priority.
key before each new job you want to give interrupt priority.
The Scanner Operator Panel will automatically return to the top layer and the
default settings after the time defined in the ‘Panel Time-out’ setting in the Océ
Settings Editor (see ‘Find system settings in the Settings Editor’ on page 139).
default settings after the time defined in the ‘Panel Time-out’ setting in the Océ
Settings Editor (see ‘Find system settings in the Settings Editor’ on page 139).