Справочник Пользователя для IBM TDS800
72
Océ TDS800 User Manual
Make a scan-to-file
Do the following to scan an original to file.
▼
How to scan to file
1
Place your original face-up, left aligned along the original guide.
2
Select the appropriate original type.
3
Select the ‘Destination’ card in the ‘File’ section.
[24] ‘Destination’ card in the file section
4
Select ‘File mode’ On.
The status message displays: Ready to scan to file.
The status message displays: Ready to scan to file.
5
Select a Destination (see ‘Destinations’ on page 82).
6
Set the correct settings. (see Chapter , ‘Settings for scan-to-file’ on page 74)
7
Press the start key
.
The original is scanned.
A status message displays (see Figure 25 on page 72):
‘Scanning job’ ‘Scan job number X’
‘File scan22.tif’
A status message displays (see Figure 25 on page 72):
‘Scanning job’ ‘Scan job number X’
‘File scan22.tif’
[25] File card on the Scanner operator panel