Справочник Пользователя для Mitsubishi Electronics SDP-ECO 1630 III

Chapter 3  Handling Plates

When plate end is displayed, remove the plate and re-set a new one following
the procedure below.

1) When 

is displayed on the panel:

The plate ended during exposure, so it is discharged from the processor.

Stop the buzzer by pressing the 

(reset) key.

After the plate is discharged, press the 

key to shift to the local mode,

and mount a new plate following the procedure mentioned in "3.1 Plate
setting".

Whether or not data will be

exposed depends on the

amount of exposure data

remaining when the plate end

is detected.

2) When is 

displayed

on the panel:
Plate ended at the beginning of an

exposure, so the remainder is

shorter than the processor's

minimum transfer length.  Please

remove the plate.

1. Open the front door and remove

the plate through the plate removal

port.

2. Close the door and press the

key to return to the local mode.

3. Re-set the plate following the

procedure mentioned in "3.1 Plate
setting".

Pick up plate

Note

MENU

<Plate End>

- 23 -

Cover for the plate
removal port

Plate removal port