Справочник Пользователя для Mitsubishi Electronics SDP-ECO 1630 III

After repeated prepress operations, silver residue from plates, paper dust,

chemicals, etc. may stick to the tank and/or processor rack, and stain

subsequent separations.

- Always clean the sections shown below when you replace the processing

chemical every three months.

- Always follow the procedures in  "4.9 Turning OFF the power supply and

inspection at shutdown" on page 34 before shutting down the machine.

You must thoroughly read "1.3 Handling processing chemicals".

•

1) Turn OFF the main power switch.
2) Lay out the maintenance mat.
3) Open the front door and remove

the replenisher bottle.

4) Discard the SLM-EAC and

SLM-EST into the waste chemi-
cal tank.

5) Hold the handle for the processor

rack section and pull out the
processor rack until it touches the
stopper.

Caution

Note

•

1) Pressing the 

key bring up the 

window on the display

panel.

2) Press the 

key to select the 

and then Press the 

key.

3) Press the 

key when 

is displayed.

4) When 

is displayed, press the 

key to bring up the 

display and then select CLR.

5) Press the 

key resets the punch counter.

ENT.

< COUNT••••CLR

<MODE>

PUNCH DRYER >

ENT.

ENT.

<MODE>

< Plate Data >

MENU

Chapter 7  Maintenance

- 51 -

Maintenance
mat

Waste chemical tank

Replenisher
bottle

SLM-EST
waste
chemical
hose

SLM-EAC
waste
chemical
hose