Справочник Пользователя для Sharp FO-DC500
Verification Stamp Option
70
3
Press
and then
or
until the desired setting is selected.
•
Note: “TX” stands for “transmission”
and “RX” stands for “reception”.
“AUTO” and “MANU” indicate AUTO
and MANUAL reception modes.
and “RX” stands for “reception”.
“AUTO” and “MANU” indicate AUTO
and MANUAL reception modes.
4
Press .
5
Go back to Step 3 to select a setting for the other line, or press
to
exit.
START/
ENTER
ENTER
START/
ENTER
ENTER
STOP
Settings for Line 1:
LINE 1 SETTING
1=TX AND RX (AUTO)
2=TX AND RX (MANU)
3=RX (AUTO) ONLY
4=RX (MANU) ONLY
2=TX AND RX (MANU)
3=RX (AUTO) ONLY
4=RX (MANU) ONLY
Settings for Line 2:
LINE 2 SETTING
1=TX AND RX (AUTO)
2=TX ONLY
3=RX ONLY
2=TX ONLY
3=RX ONLY
Verification Stamp Option
When transmitting a document, you can have the machine stamp each
document page as it is scanned. After scanning, you can check to see if all
documents have been stamped to verify that no double feeds occurred. (A
double feed occurs when two pages are fed through the scanner at once,
which means that one of the pages is not scanned.)
document page as it is scanned. After scanning, you can check to see if all
documents have been stamped to verify that no double feeds occurred. (A
double feed occurs when two pages are fed through the scanner at once,
which means that one of the pages is not scanned.)
To use this function, have your dealer install the Verification Stamp option,
and then set Option Setting 29 to ON as explained on page page 197.
and then set Option Setting 29 to ON as explained on page page 197.