Справочник Пользователя для Sharp FO-DC500

Introduction

The following steps are required to use the network scanner option. The steps 
must be completed in the order shown.

1. Your dealer must install the FO-LN1 network interface kit and the FO-NS2 
network scanner kit, and enter the network scanner product key. The machine 
must be connected to the network.

2. Your network administrator must decide whether the machine will be 
assigned a permanent IP address, or receive an address automatically from a 
DHCP server (assigning a permanent IP address is recommended; if DHCP 
is used, the lease time for the address should be set to unlimited). If a 
permanent IP address is to be assigned, the network administrator must 
determine what address will be used, and identify the subnet mask and 
gateway. Once this information has been determined, the IP address setting 
should be completed in the machine as explained on page 75.

        ❏ Permanent IP address    ❏ DHCP server

3. The following information must be entered in the Web page in the machine 
using a Web browser on a computer connected to the same network. This 
procedure is explained on page 79. Obtain the information from your network 
administrator.
-The IP address or host name of your e-mail server
     IP address (         .         .         .         ) Host name (                                  )
-The IP address of your DNS server                 (                                      )
-Your domain name                                            (                                      )
-Your network administrator’s e-mail address (                                      )

4. Scan to E-mail setup must be completed as explained on page 84.

5. To use Scan to Desktop, you must install the Network Scanner Tool and 
Sharpdesk programs in your computer. These programs are installed from the 
CD-ROM that comes with the network scanner kit (see page 96 for installation 
instructions). User’s guides in PDF format for the programs are also included 
on the CD-ROM.

6. Destinations for Scan to E-mail and Scan to FTP can be programmed into 
Rapid Key and Speed Dial numbers using the Web page in the machine. 
These procedures are explained on page 81.

 

Scan to E-mail destinations can 

also be programmed using the operation panel of the machine as explained 
on page 89. To use a Rapid Key or Speed Dial number to transmit a scanned 
document, see pages 89 and 91. To transmit a scanned document to an e-
mail address without using a Rapid Key or Speed Dial number, see page 87.