Справочник Пользователя для Ultra electronic M9006-654E

 
 
 
 
 

Page 9 of 31 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 

 Lift the card feed hopper vertically until significant resistance is felt, then tilt it backwards until it 

comes to a stop at an angle of about 30º. 

 (If it is necessary to completely remove the card feed hopper for any reason, simply lift it again 
while it is held at this angle.) 

 

 

 

 

 Open a clean pack of cards.  

(Ensure they are not electro-statically charged and sticking together). 

 Avoid touching the card surfaces as finger oils will degrade the image quality. 

 

 

 

 

 Tilt the hopper forward to the vertical position, and lower all the way down until it is completely 

within the body of the printer. 

(For loading Mag Stripe or HoloPatch cards see box on the left.) 

 

 

 

Make sure the stripe is on the right and underneath when viewed from the front of the printer. 
 

The standard position gold foil patch on the cards should be on top, and on the right-hand 
side when viewed from the front of the printer. 
 

The black edge must be on the right-hand side when viewed from the front of the printer.