Справочник Пользователя для Xerox C118

NOTE: To avoid jams and misfeeds, do not load paper on top of any remaining paper 
in the tray. Remove the paper, and reload it on top of the new stock loaded.

When loading paper into Tray 1, push 
the metal plate down until it clicks.

To load paper into Tray 2, 3, and 4, go to 
step 3.

If required, move the paper tray guides 
further out to load the new stock.

To adjust the side and rear guides, pinch 
the guide lever on each guide and slide 
the guides to their new position.
To secure the guides in position, release 
the levers.

NOTE: Tray 1 can only be loaded with plain paper. Tray 2,3, and 4 can be loaded with 
a variety of different media stock. When changing the type of stock in the tray, refer to 
Supported Paper Types on page 75. For more information about reprogramming the 
paper type, contact the Key Operator.

Load the paper neatly and tightly 
against the left-hand side of the tray 
with the print side facing upward. Tray 1 
can hold up to a 27 mm (1.1 inches) 
stack of paper. Tray 2, 3, or 4 can hold 
up to a 54 mm (2.1 inches) stack of 
paper.

NOTE: Do not load paper above the 
maximum fill line.

NOTE: When making single/double sided copies on perforated paper, load the paper  
to feed the opposite side of the perforated side edge first. Feeding the perforated side 
edge first might cause paper jams

If the paper guides have been moved, 
slide the guides to just touch the edge of 
the paper.