Справочник Пользователя для HP (Hewlett-Packard) 4100TN
62 Chapter 2 - Printing tasks
EN
Printing transparencies
Use only transparencies recommended for use in laser printers. For
transparency specifications, see “Transparencies” on page 196
transparency specifications, see “Transparencies” on page 196
●
Load transparencies face up in tray 1 with the top toward the
printer. Up to 50 transparencies can be loaded in tray 1.
printer. Up to 50 transparencies can be loaded in tray 1.
●
A stack of 50 to 100 transparencies can be printed from tray 2, 3,
or 4 (although stacking more than 50 at a time is not
recommended). Because transparencies are heavier than paper,
do not load tray 2, 3, or 4 to capacity. Load them with the side-to-
be-printed facing down, and the top edge toward you.
or 4 (although stacking more than 50 at a time is not
recommended). Because transparencies are heavier than paper,
do not load tray 2, 3, or 4 to capacity. Load them with the side-to-
be-printed facing down, and the top edge toward you.
●
To prevent transparencies from becoming too hot or sticking
together, use the top output bin.
together, use the top output bin.
●
Remove each transparency from the output bin before printing
another.
another.
●
Do not feed transparencies through the printer more than once.
●
Print only on one side of a transparency.
●
Place transparencies on a flat surface to cool after removing them
from the printer.
from the printer.
●
Select the transparency paper type from the printer driver so that
the printer uses the low fuser mode that is best for printing them.
the printer uses the low fuser mode that is best for printing them.
●
If two or more transparencies feed at the same time, try fanning
the stack.
the stack.