Справочник Пользователя для JVC DT-V17L2D
4
Installation
CAUTION
• Do not rest your arm on the monitor or lean against the monitor.
• Do not touch the LCD panel when installing the monitor.
• Make sure to install the monitor securely to prevent the monitor from falling over, which causes damage to the monitor
• Do not touch the LCD panel when installing the monitor.
• Make sure to install the monitor securely to prevent the monitor from falling over, which causes damage to the monitor
or injury.
You can place the monitor in the following two ways when using the monitor on the supplied stand.
You can tilt the monitor from about 6° upward to
about 6° downward.
• When the monitor is not tilted (0°), the guidelines
about 6° downward.
• When the monitor is not tilted (0°), the guidelines
align as illustrated below.
When the stand plate is attached to the higher
position of the stand body (
position of the stand body (
☞ “To adjust the stand
height” on page 5), you can lift the stand up by about
148° and place the monitor as illustrated below.
• Remove the screws on the left and right sides of
148° and place the monitor as illustrated below.
• Remove the screws on the left and right sides of
the stand (see the illustration below), then lift the
stand up by about 148°.
Make sure of attaching the removed screws after
lifting up the stand.
stand up by about 148°.
Make sure of attaching the removed screws after
lifting up the stand.
• To place the monitor as illustrated on the left again,
remove the screws on the left and right sides of the
stand, return the monitor angle to 0°, then attach
the removed screws.
stand, return the monitor angle to 0°, then attach
the removed screws.
To detach the stand
CAUTION
Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.
CAUTION
• Be careful not to pinch your fingers in the gap between
the monitor and the stand.
• When the stand plate is attached to the lower position
of the stand body (
☞ “To adjust the stand height” on
page 5), you cannot tilt the monitor downward.
About 6°
About 6°
CAUTION
• When lifting up the stand, lay the monitor on a cloth
with the LCD panel facing down to prevent the LCD
panel being damaged.
panel being damaged.
• Be careful not to pinch your fingers in the moving
parts.
• Make sure to lift the stand up until it stops (about
148°); otherwise the monitor may fall over.
• Place the monitor on a mat to avoid scratching the
table surface.
• Do not lift up the stand when the stand plate is
attached to the lower position of the stand body (
☞ “To
adjust the stand height” on page 5).
• When the battery is attached, the stand may not be
lifted up depending on the type of the battery.
Screw holes for
stand attachment
Screw holes for stand attachment
(on the monitor)
(on the monitor)
Screw holes for stand attachment
(on the stand)
Stand body
Guides
Guide holes
Attachment screws
Monitor
Monitor
When installing the stand to the monitor, insert the guides of the stand into the guide holes on the monitor
to place the stand on the correct position. Then fix the stand firmly with the attachment screws.
to place the stand on the correct position. Then fix the stand firmly with the attachment screws.
About 148°
0°
Guidelines
Screw (silver)
Stand plate
DT-V17L2D_EA_EN_R.indd 4
DT-V17L2D_EA_EN_R.indd 4
07.9.14 7:01:41 PM
07.9.14 7:01:41 PM