Справочник Пользователя для Sony GDM-5510

5

This monitor works with platforms running at horizontal 
frequencies between 30 and 130 kHz.

Turn off the monitor and computer before connecting.

Notes
• Do not touch the pins of the video signal cable connector as this might 

bend the pins.

• When connecting the video signal cable, check the alignment of the 

HD15 connector. Do not force the connector in the wrong way or the 
pins might bend.

x Connecting to the 13W3 connector

x Connecting to the HD15 connector

With the monitor and computer switched off, first connect the 
power cord to the monitor, then connect it to a power outlet.

First turn on the monitor, then turn on the computer.

The installation of your monitor is complete.
If necessary, use the monitor’s controls to adjust the picture.

• Check that the monitor is correctly connected to the computer.
• If NO SIGNAL appears on the screen, try changing the input 

signal (page 6), and confirm that your computer’s graphics 
board is completely seated in the correct bus slot. 

• If you are replacing an old monitor with this model and OUT 

OF SCAN RANGE appears on the screen, reconnect the old 
monitor. Then adjust the computer’s graphics board so that the 
horizontal frequency is between 30 – 130 kHz and the vertical 
frequency is between 48 – 170 Hz.

For more information about the on-screen messages, see “Trouble 
symptoms and remedies” on page 17.

To a computer with 
a 13W3 video output

To a computer with 
an HD15 video output

to AC IN

to a power outlet

power cord