Справочник Пользователя для Sony PLM-S700E
45
-GB
Additional Information
Troubleshooting
If you have any questions or problems not listed below, contact your Sony dealer or local
authorised Sony service facility.
authorised Sony service facility.
continued
Cause
Connections are incorrect.
The signal is not input.
The Glasstron enters power save
mode.
mode.
When you connect to a notebook
type PC, the display mode is set to
local display mode (LCD panel of
your notebook PC).
type PC, the display mode is set to
local display mode (LCD panel of
your notebook PC).
You are not wearing the Glasstron
correctly.
correctly.
—
—
The inside window (where the
picture is displayed) is dirty.
picture is displayed) is dirty.
A warning was displayed for more
than two minutes. (The Glasstron
turned off automatically.)
than two minutes. (The Glasstron
turned off automatically.)
You continued using the Glasstron
for six hours. (The Glasstron turns
off automatically after six hours to
prevent eye fatigue.)
for six hours. (The Glasstron turns
off automatically after six hours to
prevent eye fatigue.)
The battery pack or batteries are
dead.
dead.
You put off the Glasstron while the
POWER SAVE is set to ON.
POWER SAVE is set to ON.
—
The AVLS function is on.
The equipments are not connected
propely.
propely.
Sound volume of the connected
computer is inappropriate.
computer is inappropriate.
The battery pack is not charged
enough.
The battery pack is completely dead.
enough.
The battery pack is completely dead.
Remedy
Connect the equipment correctly
(pages 14 to 19).
(pages 14 to 19).
Select the correct input (page 30).
Put the Glasstron on again to bring
the forehead near to the POWER
SAVING SENSOR (page 13).
the forehead near to the POWER
SAVING SENSOR (page 13).
Change the display mode. For
details, refer to the instruction
manual of your PC.
details, refer to the instruction
manual of your PC.
Put on the Glasstron correctly (pages
20 and 21).
20 and 21).
Adjust the brightness with the
BRIGHT control (page 31).
BRIGHT control (page 31).
Adjust the RGB signal
synchronization (page 38).
synchronization (page 38).
Clean the display unit with a soft,
dry cloth.
dry cloth.
—
—
Charge the battery pack or replace with
new batteries (pages 40).
new batteries (pages 40).
Put the Glasstron on again to bring
the forehead near to the POWER
SAVING SENSOR (page 13).
the forehead near to the POWER
SAVING SENSOR (page 13).
Adjust the volume with the VOL
control (page 31).
control (page 31).
Set AVLS in the menu to OFF (page
37).
37).
Connect the equipments correctly
(pages 14 to 19).
(pages 14 to 19).
Adjust the volume on the computer.
Charge the battery pack fully or use a
new one (page 40).
new one (page 40).
Symptom
The picture does not
appear.
appear.
The picture is dark or
dim.
dim.
The picture suddenly
disappears.
disappears.
The picture has no sound.
The sound is noisy.
The sound is noisy.
The volume does not
become louder.
become louder.
The battery pack
discharges quickly.
discharges quickly.