Справочник Пользователя для Sony LMD7220W

Location and Function of Parts and Controls

GB 

8

A POWER switch and indicator

Each time you press the switch, the power is turned on 
or off.  When the power is turned on, the indicator 
lights in green.

B Tally lamp

You can check the status of the monitor that the signal 
is input by the color.
The lamp lights in red or green by signals from the 
equipment connected to the REMOTE connector.  
When red and green signals are input, the lamp lights 
in amber.
The pins on the REMOTE connector are used to 
control the tally lamp.
For details, see page 9.

C Aspect select button and indicator (LMD-

Sets the aspect ratio of the picture.  When the button is 
pressed, the aspect ratio of the picture is set to 4

:3 and 

the indicator lights.

D CONTRAST control

Turn this control clockwise to make the contrast 
higher or counterclockwise to make it lower.

E PHASE control

This control is effective only for the NTSC color 
system.
Turn it clockwise to make the skin tones greenish or 
counterclockwise to make them purplish.

F BRIGHT (brightness) control

Turn this control clockwise to increase the brightness 
or counterclockwise to decrease it.
Indistinctness of the picture when the viewing angle of 
the monitor is adjusted may be compensated by 
adjusting the brightness.

G CHROMA control

Turn this control clockwise to increase the color 
intensity or counterclockwise to decrease it.

You can adjust the viewing angle of LMD-5320/7220W 
up to 10 degrees upward or downward and LMD-4420 
up to 8 degrees upward or 10 degrees downward.

When the AC adaptor is attached to the monitor and the 
angle is adjusted, the AC adaptor may be touched to the 
equipment set to upper or lower.  Remove the AC 
adaptor holder from the monitor.

Press the center top.

Press the center bottom.