Справочник Пользователя для Philips 97 (1)

 

DDC Data Re-programming 

In case the main EEPROM with Software DDC which store all factory settings were replaced because a defect, 

repaired monitor’ the serial numbers have to be re-programmed. 

It is advised to re- soldered the main EEPROM with Software DDC from the old board onto the new board if 

circuit board have been replaced, in this case the DDC data does not need to be re-programmed. 

Additional information about DDC (Display Data Channel) may be obtained from Video Electronics Standards 

Association (VESA). Extended Display Identification Data (EDID) information may be also obtained from 

VESA. 

1. An i486 (or above) personal computer or compatible. 

2. Microsoft operation system Windows 95/98/2000/XP. 

3. “ PORT95NT.exe, WinDDC_ setup” program. 

4. Software OSD SN Alignment kits   

b. Printer cablex1    

c. VGA cable x1   

d. Digital cable x1