Справочник Пользователя для Philips 245P2
50
7. Troubleshooting & FAQs
7.1 Troubleshooting
This page deals with problems that can be
corrected by a user. If the problem still persists
after you have tried these solutions, contact Philips
customer service representative.
corrected by a user. If the problem still persists
after you have tried these solutions, contact Philips
customer service representative.
Common Problems
No Picture (Power LED not lit)
•
•
Make sure the power cord is plugged into the
power outlet and into the back of the monitor.
power outlet and into the back of the monitor.
•
First, ensure that the power button on the
front of the monitor is in the OFF position,
then press it to the ON position.
front of the monitor is in the OFF position,
then press it to the ON position.
No Picture (Power LED is white blinking)
•
•
Make sure the computer is turned on.
•
Make sure the signal cable is properly
connected to your computer.
connected to your computer.
•
make sure the monitor cable has no bent pins
on the connect side. If yes, repair or replace
the cable.
on the connect side. If yes, repair or replace
the cable.
•
The Energy Saving feature may be activated
Screen says
•
Make sure the monitor cable is properly
connected to your computer. (Also refer to
the Quick Set-Up Guide).
connected to your computer. (Also refer to
the Quick Set-Up Guide).
•
Check to see if the monitor cable has bent
pins.
pins.
•
Make sure the computer is turned on.
AUTO button doesn't function
•
•
The auto function is applicable only in
VGA-Analog mode. If the result is not
satisfactory, you can do manual adjustments
via the OSD menu.
VGA-Analog mode. If the result is not
satisfactory, you can do manual adjustments
via the OSD menu.
Note
The Auto Function is not applicable in
DVI-Digital mode as it is not necessary.
DVI-Digital mode as it is not necessary.
Visible signs of smoke or sparks
•
•
Do not perform any troubleshooting steps
•
Disconnect the monitor from mains power
source immediately for safety
source immediately for safety
•
Contact with Philips customer service
representative immediately.
representative immediately.
Imaging Problems
Image is not centered
•
•
Adjust the image position using the “Auto”
function in OSD Main Controls.
function in OSD Main Controls.
•
Adjust the image position using the Phase/
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.
Image vibrates on the screen
•
•
Check that the signal cable is properly securely
connected to the graphics board or PC.
connected to the graphics board or PC.
Vertical flicker appears
•
Adjust the image using the “Auto” function in
OSD Main Controls.
OSD Main Controls.
•
Eliminate the vertical bars using the Phase/
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.