Справочник Пользователя для Mitsubishi Electronics DV156
6
4
4
Hardware Installation
Your monitor is equipped with an automatic power supply with a voltage
range from 90 to 264 Volts AC at a frequency of 50 to 60 Hz. Make sure that
your local power supply is within the supported range. If you are unsure,
please contact your electricity supplier.
range from 90 to 264 Volts AC at a frequency of 50 to 60 Hz. Make sure that
your local power supply is within the supported range. If you are unsure,
please contact your electricity supplier.
To install your Diamond View DV156 monitor:
1. Make sure that the power to the computer and the power to the monitor
are both turned off.
2. Connect the blue connector of the monitor’s VGA cable to the VGA
output of the computer‘s graphics card.
3. Connect
the
monitor‘s power cord to an AC power socket. Please make
sure, that you have easy access to the power socket so you can
disconnect the unit from the power socket should you need to.
disconnect the unit from the power socket should you need to.
VGA Signal Cable
Power Cable