Справочник Пользователя для Mitsubishi Electronics LCD4000
English-10
To avoid falling down
Fasten the LCD monitor to wall or pillar with a cord or chain
which is sufficient to support the weight of the LCD monitor
(approx. 31.5kg).
which is sufficient to support the weight of the LCD monitor
(approx. 31.5kg).
Before moving the LCD monitor, the cord or chain should be
removed.
removed.
Ventilation Requirements for enclosure
mounting
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram to the right.
objects as shown in the diagram to the right.
Screw Holes
Clamper
Cord or Chain
100mm
100mm
100mm
100mm
100mm
Ambient temperature should be less than 40°C.
* Use some fans as needed.
*
*
400mm
Screw
You can attach mounting accessories to the LCD monitor in
one of the following two ways:
one of the following two ways:
In the upright position
How to Mount and Attach Options to the LCD Monitor
Lay the screen face down
Lay the protective sheet on a table, which was wrapped
around the monitor when it was packaged, beneath the
screen surface so as not to scratch the screen face.
around the monitor when it was packaged, beneath the
screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow correct
mounting procedures could result in damage to the
equipment or injury to the user or installer. Product warranty
does not cover damage caused by improper installation.
Failure to follow these recommendations could result in
voiding your warranty.
Stand or other mounting accessory. Failure to follow correct
mounting procedures could result in damage to the
equipment or injury to the user or installer. Product warranty
does not cover damage caused by improper installation.
Failure to follow these recommendations could result in
voiding your warranty.
When using with other mounting accessory, it must be a
VESA-compatible mounting method and the screws must be
M6 of size and 8mm or longer of length under consideration
of the thickness of the mounting method. (Recommended
torque: 274 ~ 362N.cm). NEC recommends using mounting
interface that comply with UL1678 standard in North
America.
VESA-compatible mounting method and the screws must be
M6 of size and 8mm or longer of length under consideration
of the thickness of the mounting method. (Recommended
torque: 274 ~ 362N.cm). NEC recommends using mounting
interface that comply with UL1678 standard in North
America.
Protective Sheet
Tabletop Stand
Table