Справочник Пользователя для Matrox Electronic Systems DVI G450

Matrox Graphics Card – User Guide

Make sure

Matrox System Utilities

are installed on your computer. (These can be

installed from your Matrox CD-ROM.)

Windows 98/Me/2000/XP or NT 4.0 – Click

Start

Run

, type c:\matrox\util\pbioswin,

then click

. Follow the on-screen instructions.

DOS – Restart your computer in DOS mode, then type:

cd c:\matrox\util [Enter]
upbiosdos [Enter]

Turn off your computer, remove the other graphics card, then plug your monitor into
your Matrox graphics card.

Restart your computer.

Problem

Wrong color balance, screen image off-center, or no picture at all

Cause

Your monitor video controls may be improperly set.

Solution

Adjust your monitor controls (brightness, contrast, and so on). For more information, see
your monitor manual.

Cause

Your monitor may not be properly connected.

Solution

Make sure your monitor is properly connected to the correct connector on your Matrox
graphics card (

see “Connection setup”, page 4

Solution

Make sure the monitor power cable is firmly in place.

Note:

Make sure your computer uses the other graphics card to control your primary

display. The graphics card that controls your primary display is the one that first displays
information when you restart your computer. (A DualHead-supporting graphics card
may display this startup information on both of its displays at the same time.)

Your computer BIOS (Basic Input/Output System) and the slot type (ISA, PCI, or AGP
–

see “Choose an expansion slot”, page 3

) of each graphics card help determine which

graphics card controls your primary display.

To control which graphics card is used for your primary display, you may be able to
change the configuration of your computer BIOS. For information on how to change
your computer BIOS settings, see your system manual.