Справочник Пользователя для Netgear Business Edition

Managing Levels of Service

6-7

4. Press the recessed reset button at the back to confirm the menu selection and proceed to that 

option.

The system will boot reset to the fatory default settings. 

You can switch between the X-RAID2 Expandable Volume mode and the RAID 0/1/5/6 Flexible 
Volume mode only if you want to change the default configuration. It is not necessary to perform 
this procedure every time you boot up the system. The device remains in the selected mode until 
explicitly changed.

To reconfigure your RAID setup:

1. Power off the device.

2. Use a paper clip or push pin to gently press in and hold the reset switch, power on the unit and 

hold the reset switch for 30 seconds while powering on the device until the Boot Menu prompt 
appears on the OLED, then release the reset switch.

3. Push the Backup button on the front panel to scroll through the menu to the Factory Default 

option.

4. Press the recessed reset button at the back to confirm the menu selection and proceed to that 

option.

The system will reset to the factory default settings, and erase all the data on the disks. 

5. Open RAIDar. RAIDar will prompt you to click Setup. The ReadyNAS Volume Setup screen 

displays.

6. Select either the Expandable Volume (X-RAID2) or the Volume (RAID 0,1,5, 6) radio 

button and click Create Volume Now. The volume and initialization process begins.

Warning: Performing a Factory Default will erase all your data on the hard disks. To 

preserve you data, do a full backup before using the Factory default option.

Warning: If no action is taken within 10 minutes, the system defaults to X-RAID2 

with 10 GB reserved for snapshots.