Справочник Пользователя для Seagate ST32112A
Medalist 8421, 6421, 4311 and 2112, Rev. A
7
Note. If you are using the 80-conductor cable, attach the blue
connector (with the longest section of the cable) to the
motherboard, attach the black connector to the master or
single drive, and attach the grey connector to the slave.
motherboard, attach the black connector to the master or
single drive, and attach the grey connector to the slave.
Caution. To avoid possible damage to your system,
make sure to align pin 1 on the motherboard with pin 1
on your drive. Pin 1 on the interface cable is usually
indicated by a stripe along the edge of the cable.
make sure to align pin 1 on the motherboard with pin 1
on your drive. Pin 1 on the interface cable is usually
indicated by a stripe along the edge of the cable.
Figure 3. Mounting screws
3. You can mount the drive in any orientation. Usually it is
mounted with the circuit board down.
4. Slide the drive carefully into the drive bay. Secure the drive
with four 6-32 UNC mounting screws in either the side-
mounting holes or the bottom-mounting holes. Insert the
screws no more than 0.22 inch (5.58 mm) into the bottom-
mounting holes and no more than 0.20 inch (5.0 mm) into the
side-mounting holes.
mounting holes or the bottom-mounting holes. Insert the
screws no more than 0.22 inch (5.58 mm) into the bottom-
mounting holes and no more than 0.20 inch (5.0 mm) into the
side-mounting holes.
!