Справочник Пользователя для Seagate ST373405LW/LWV/LC/LCV
38
Cheetah 73LP Product Manual, Rev. E
Figure 17.
J2 option select header
8.1.1
[1]
Notes explaining the functions of the various jumpers on jumper header connectors J2, J5, and J6 are
given here and in Section 8.1.2. The term “default” means as standard OEM units are configured with a
jumper on those positions when shipped from factory. “Off” means no jumper is installed; “On” means a
jumper is installed. OFF or ON underlined is factory default condition.
given here and in Section 8.1.2. The term “default” means as standard OEM units are configured with a
jumper on those positions when shipped from factory. “Off” means no jumper is installed; “On” means a
jumper is installed. OFF or ON underlined is factory default condition.
The PCBA on LC/LCV models does not have connector J5. The J5 connector signals conform to SFF-
8009 Revision 2.0, Unitized Connector for Cabled Drives, signal assignments for auxiliary connectors.
8009 Revision 2.0, Unitized Connector for Cabled Drives, signal assignments for auxiliary connectors.
[2]
[3]
Voltage supplied by the drive.
Delay Motor Start
Enable Remote Motor Start
Write Protect
Parity Disable
Term. Power to SCSI Bus
S
E
E
D
S
S
M
E
W
P
P
D
D
R
E
S
E
S
R
E
S
E
S
T
P
P
Jumper
Positions
Force single-ended bus mode
(applies to LW/LWV models only;
reserved on LC/LCV models)
reserved on LC/LCV models)
Pin 1
Reserved
J2
J2
Jumper Plug
(enlarged to
show detail)
show detail)
[3]
*
Additional notes on these
functions in section 8.1.2.
J2
Drive
Front
Front
J6