Справочник Пользователя для Q-Logic 8200 SERIES
3 – SANbox SSP Management GUI Reference
Managing SANbox SSP
SN0054628-00 A
3-5
Q
2. After typing the username and password, click Logon.
3. QLogic recommends that you change the password if you did not already do
so during setup:
■
If you are using the SANbox SSP Management GUI, change the password
on the Telnet screen. See
on the Telnet screen. See
for more information.
■
.
3.1.2
Using the Command Line Interface (Remotely)
You can remotely connect to the CLI through telnet or ssh. Before you can access
the CLI remotely, you must configure the management port (labeled
the CLI remotely, you must configure the management port (labeled
on the port
side of SANbox SSP). If you did not yet configure the management port for remote
access, see
access, see
.
After you access the CLI through telnet or ssh, see
for information about basic operation and configuration commands.
To access the CLI using telnet:
For more information about remotely accessing the CLI through telnet, see
To access the CLI using ssh:
You can download a free ssh client from
. The ssh command
line to log in to the management IP address is:
ssh kadmin@10.4.2.123
3.1.3
Using the Command Line Interface (Locally)
Most users access the CLI locally only once for configuration when starting the
SANbox SSP for the first time. If you have not yet completed this step, see
SANbox SSP for the first time. If you have not yet completed this step, see