Справочник Пользователя для Q-Logic 8200 SERIES
SN0054628-00 A
4-1
Section 4
Using the SANbox SSP
This section provides procedures for using the SANbox SSP, including SAN zoning,
configuring storage, creating virtual disks, interpreting LEDs, and shutting down.
configuring storage, creating virtual disks, interpreting LEDs, and shutting down.
This section describes the following procedures:
■
■
■
■
■
■
4.1
Setting up a High-Availability Configuration
provides the specific requirements for each component that is part of the
recommended high-availability configuration. The table presents the information for
a highly available configuration with a single host.
a highly available configuration with a single host.
Table 4-1. Required Configuration for the Components
of a High-Availability System
Component
Type
Minimum
Required
Required Configuration per Component
Host
1
■
Supported high-availability or multi-pathing software
installed.
installed.
■
Connected to both SANbox SSPs in the high-availability
solution, and not connected to any other SANbox SSPs.
solution, and not connected to any other SANbox SSPs.
HBA
2 per host
■
Each connected to one SANbox SSP (directly or through
a fabric). Each must see only one SANbox SSP.
a fabric). Each must see only one SANbox SSP.
SANbox SSP
2
■
Each can access all storage ports.
■
Each connected to both SVM appliances through the
back-side fabric.
back-side fabric.
StoreAge SVM
Appliance
Appliance
2
■
Each one connected through the back-side fabric to both
SANbox SSPs.
SANbox SSPs.
■
Each one can access all storage ports.